2000 Honda Accord Radio Removal

2000 Honda Accord Radio Removal. Web how to remove the radio on a 2000 honda accord. 2.1) pull top edge of triangular panel from door panel and lift up from.

How to remove factory radio from 2000 honda crv
How to remove factory radio from 2000 honda crv from automotorpad.com

Web this is an instructional video showing how to remove a radio console from a honda accord vehicle.comment below what other car removal videos you want to see. Access to the radio requires the removal of the complete plastic fascia. Remove the upper panel with a flat pry and disconnect anything, just put the panel.

The Tape Player Broke On.


You should be able to adjust the settings from there. Honda accord how to remove and install car stereo: Access to the radio requires the removal of the complete plastic fascia.

Take Care Not To Scratch The Dashboard, Body And Other Related Parts.


Web this is an instructional video showing how to remove a radio console from a honda accord vehicle.comment below what other car removal videos you want to see. Web locate and remove two (2) ic mm bolts, (1) one each side of the box. Web an assistant is helpful when removing and installing the dashboard.

1.1) Pry Edge Of Plastic Lock On Control Box Out Of Mounting Bracket.


Put on gloves to protect your. Erelannon september 11, 2011, 10:38pm #1. 2.1) pull top edge of triangular panel from door panel and lift up from.

Web The Radio Is Secured By Four (4) Screws:


1.1) remove door panel pin from front of door panel. Web thu 28 jun 2007 20:01. Remove the screws and pul the radio out of the dash.

Grab The Box And Allow It To Fall To The Carpe _ Once The Screws Are Removed, The Radio Can Be Pulled Out.


Your vehicle will either have four (4) phillips screws or four (4) 8 mm bolt screws. Web when they are pushed fully in, the extractors unlock the retaining spring and latch themselves firmly the radio, so you can use the extractors to pull the radio out of. Remove the upper panel with a flat pry and disconnect anything, just put the panel.